Bump stops

[Lizardmen3477]

How did you get them out to cut them? And this doesnt have any visual side effects? just smoother ride?

[VX KAT]

I used a hacksaw to cut mine, probably took about 10 minutes per stop due to my dull blades and obsessive-compulsive desire to make them perfectly flat on the bottom.

How did you get them out to cut them? And this doesnt have any visual side effects? just smoother ride?

My mechanic used a Sawzall while up on the lift. Allowed the wheel/axle to drop down, gave him more space to work in.

The rear bump stop is the black thing. At the bottom of the figure 8 you can see a tan colored area (that's AZ desert dirt!). Can also see it's basically touching my axle! The bottom half of the figure 8 is what we cut off, so that tan part is no longer there.

Can also see the hardware attaching it to the truck, right above it, you can see the bolt head, also tan colored. There's 2 bolts holding it on, one on each side of the 8.

Absolutely nothing visually is changed by doing this. Just a nicer ride!