I just spoke with both Craig & Sean at RCV. Craig is the salesman & Sean is the Engineer.

Sean is going to try to get all of his detailed measurements from my half shafts this week. He will be able to return everything after he completes that.

He will also be able to get us a cost estimate then as well.

I think that I'll have him return the axles to me so that I can check a few things before I send that one shaft & outer race to you.

BTW, for future reference (according to Sean):

Half shaft refers to the entire axle assembly which includes the axle (sometimes referred to as bar or rod) from the pumpkin, inner CV, the splined shaft between the CVs (he called it the center bar), the outer CV & the outboard axle that splines into the wheel assembly.

The 'CVs for Dummies' pdf that I posted long ago shows the proper names for the other components.