And so it begins...

[Buffy]

How is that possible? Our vacuum booster is no different than any other vacuum booster in design.

That is what I wondered but the manual does state that bleeding the system without the engine running could cause damage.

On a bright side I actually had my maiden voyage today. I drove my VX to the mufler shop to have the exhaust system installed! I was in hog heaven though I was listening for every noise, creek or pop. I was pleased with how stright it drove and did not pull to either side, especially since it has not had the front end aligned yet! I think I have the ride height set close to where I want it. Sitting on a level surface the distance from the floor to the top of the rear wheel well is 34 1/2 in the rear and 33 1/2 in the front. From looking at my original pictures, it looks like it had a similar stance when I first got it. If anyone could prive me with the measurements of their suspension would be great!

I will post up some before and after pictures soon.

[RickOKC]

If anyone could prive me with the measurements of their suspension would be great!

I looked this up a while back because I thought the nose on mine was way too low (it wasn't). Here's one thread (there are others out there) that made it seem like there was a fair amount of variance on stock vehicles. It's been a while since I did the research, but I was left believing that 1-1/4" to 1-1/2" was average with the full range going from 3/4" to 2".

[Marlin]

If anyone could prive me with the measurements of their suspension would be great!

I will post up some before and after pictures soon.

38.5 to the lip of the cladding in the rear and 37 to the lip of the cladding in the front Hope that helps!!