Well with the help of a torch and a gigantic adjustable wrench (to use as my pry bar of sorts), the antenna looks like this now, I'm gonna stick with the rear mount I think. I used a cable clamp on the coax using one of the rear taillight screws and I didn't need to drill any holes in the rear plastic since there was this neat little spot that already had a small gap and the cable fit perfectly. I pulled the side paneling out just enough to slide the cable all the way under to the front and then ran under the carpet over to the CB. I mounted the bracket in a way that I could run the cable real tight without any binding so very little is actually exposed outside the truck.