Head bolt snapped!

[phines]

I'm in the process of swapping out cyl heads most of the bolts came out fine with the exception of 1 bolt. It broke off on the thread section in the block. %$#%$#$$#$@$#!!!!

You probably already know this, but you definitely want to replace every one of those bolts. Those bolts are seriously fatigued!

[Hotsauce]

Put the head back on with the remaining bolts, a little more than hand tight.

Look in mcmaster carr, or msc catalog, and find a drill jig bushing that has an od the size of the hole in the head.

buy a long carbide center drill, and using the head and bushing to center the drill, drill a pilot hole in the old cyl bolt.

Once you have this done open the hole to correct size for extractor.

John C.

[jdm monkey]

I had the same thing happen. It was on the passenger side, closest to the front. The worst part is they don't make an extractor that size that is long enough to get down into the block. My local service guy (not Isuzu) had a block-mountable drill that he used. They eventually got it out. There was no way I could have done that myself...

Yeah mine was on the passenger side at the very front closest to the frame...

You probably already know this, but you definitely want to replace every one of those bolts. Those bolts are seriously fatigued!

I have brand new ones. I'm trying to see if ARP sells studs for our engines I may need it since I'm going turbo...

Put the head back on with the remaining bolts, a little more than hand tight.

Look in mcmaster carr, or msc catalog, and find a drill jig bushing that has an od the size of the hole in the head.

buy a long carbide center drill, and using the head and bushing to center the drill, drill a pilot hole in the old cyl bolt.

Once you have this done open the hole to correct size for extractor.

John C.

I'll give it a shot

[rowhard]

Put the head back on with the remaining bolts, a little more than hand tight.

Look in mcmaster carr, or msc catalog, and find a drill jig bushing that has an od the size of the hole in the head.

buy a long carbide center drill, and using the head and bushing to center the drill, drill a pilot hole in the old cyl bolt.

Once you have this done open the hole to correct size for extractor.

John C.

good tip to remember. Is this the item your talking about? http://www.mcmaster.com/#drill-bushi...liners/=8i41m1