I followed the directions to the letter, soft flat brush, lint free rag or soft pad, went preciously 10 mins, wiped with the lint free rag, it captured any "runs"that may have formed.

Rif I don't see where step 5 or 6 mention anything about the
"and then "buff off" the R/R from the ENTIRE surface panel (not just the edges) until completely dry with a lint-free towel
. So I'm not clear on your directions. Actually that sounds more similar to the directions to 303. They're quite clear on the procedure of wiping it dry completely with a lit free rag. Can you clarify that for me?
5. Refinish Restorer should take effect 5 to 10 minutes after application. Any liquid Refinish Restorer can be
brushed over a more porous area.
6. After a maximum of 10 minutes any excess oil should be removed with an absorbent lint free cloth or a soft
pad, otherwise it can only be removed with a suitable stain remover. Liquid Refinish Restorer can be removed
using a turpentine substitute
I also did my hood insert last yr (April), just one coat, came out great and hasn't had any chipping or anything, still looks beautiful, very happy with the way it came out. Glad to hear yours came out so great too!

Just gotta be something different either I did, or the composition of my front cladding, or the environmental aspects (heat/low humidity, etc), or the shear fact that I drive on extremely rough dusty roads where the front is constantly getting pelted with debris, and then the rest is highway driving mostly 65+ limit....but I may go a wee bit over that....sometimes, and it's still a high debris/sandy/dirt environment.

Think my options are to give it another good coat of R/R (hoping the chip defects get absorbed or covered), buy a new front cladding, Line-X the whole dang cladding, find a solvent that works to remove it. Petos had limited success when he heavily recoated his trying to get it to absorb larger globs where he'd forgotten to wipe them/blend them in before it hardened.

Think I'll try to write to mfg for some tech info.

But I'm really looking forward to your details RIff on the new stuff TS-1 and seeing the results. Post some pics when you get it done! As well as RickOKC's testing.