Potential Mods - Are They Possible?

[Marlin]

Its funny reading where others say this and that isint possible....from behind there keyboard... some folks can type alot better than they can use a wrench or a welder I guess

Its funny that you mention that, cause I have done some of the things others said were not possible, but, if he had those welding/fab skills, he wouldn't have asked the questions that he did...as I said, with enough funding, anything is possible, and I agree about the SAS.
A few of the King Of The Hammer trucks run IFS. I would not be surprised if none of those trucks had less than $100K in em. (equivalent wrench time, not just parts)

[Triathlete]

A few of the King Of The Hammer trucks run IFS. I would not be surprised if none of those trucks had less than $100K in em. (equivalent wrench time, not just parts)

All were no less than D60's and the axle shafts were in the 2inch diameter range! But that race is a whole differant ballgame (I plan on being there to crew/spectate within the next few years...I have an open invite)

Like a lot said already though...everything is possible, but you need at least 1 of the following
mechanical/fab skill
or
$$$$cha-ching$$$$$$$$

[BeeVenom]

I have 20's w/265-50 series Yokohama Spec-X tires and had to trim the front cladding just a tad. Still stock suspension height.

[Marlin]

I have 20's w/265-50 series Yokohama Spec-X tires and had to trim the front cladding just a tad. Still stock suspension height.

Cool, but I think if he is gonna get into wheeling, he will probably go with 16" rim, the tires are WAY cheaper, and there is a much larger selection.

When you get ready to buy your VX, make sure you get the faster more powerful model....the Proton. (shameless plug, don't be jealous because I beat ya'll to it)