Hey Monstertrucker, I can't beleive someone I don't know was actually viewing this thread! I don't visit vx.info much anymore. But some folks asked in Moab about this project so here is an update.

The last 2 weekends have been all garage so the house and yard are farked!

Anyway... I remove the engine when I need to. As it sits here is how it will sit in the vehicle. The axles are also on casters; so is the frame..


All squared up and level. Notice how easy it is to reposition the outriggers... all by design. Giggity giggity...


My first bends!! I am proud of how all this came together. I bought BendTech Pro but have not even used it yet. I didn't want to waste tube on calibration haha


Everything is square and level too!


Bending is a workout, btw...