I so I have most everything I need to replace all for disc brakes, lines, repack the bearings then have a great day. However I have been following the guides made by forum members and can't seem to locate a bearing locknut tool. Kenny's writeup says to use the ford 1/2 ton 4 prong bearing nut tool, which I bought but its way too big. I have been to 3 parts stores this morning alone and cannot find the locknut tool I need. So my question is:

What is everyone here using? I can I get these bearings out?

My car has been jacked up for a week and really was looking forward to finishing this mess today. Thanks for any info you guys have.