cut out

[chez]

hi have had diagnostic checked shows no prob "well thats what they say" its an import so no one will touch it . fuel filter has been done and all the above .

[WormGod]

hi have had diagnostic checked shows no prob "well thats what they say" its an import so no one will touch it . fuel filter has been done and all the above .

No CEL at all but cuts out with some gas.... hmmm....

You know, mine did that for a while after sitting before. Had to jump it go get it out of my garage. Once started it idled fine, but given gas, it would stall. Strangely enough, it was "somehow" due to the low battery charge. Go figure. New battery and it was fine afterward. Makes little sense but it worked in my particular case.

Check all of your wiring harnesses. In particular, your IAC, MAF, MAS, and TPS. Look for any corrosion or dirt and/or loose connections (though I would expect a CEL if this were the case) in the sockets on those sensor plugs. Use a bit of Dielectric grease on them as well before reconnecting.

Drive some fresh hi octance and Sea Foam into your tank as well. GIve the injectors and fuel lines a solid run through.

Just some affordable ideas.