I also nabbed a protorque series starter which is smaller, lighter, more powerful, and clockable.
Protorque under stock starter
Adjustable mounting
The oil filter on the engine was changed to a remote mount setup to increase capacity and accessibility of the oil system. One of the Sprague accumulators will also be plumbed into this system to run as a pre-oiler at startup and accumulator during use.
I replaced the crank pulley with a 25% underdrive pulley which will give more horsepower, but run all the accessories slower. They make an overdrive pulley for the alternator that I will install here shortly so it spins at normal speed. So what's the point then? Well, I plan on using an industrial equipment hydraulic pump instead of a dinky power steering pump to power the hydraulic ram steering and the hydroboost system. Those pumps don't like high RPM, so I have a big pulley for them and the small underdrive pulley, and presto, everything is happy. Here's a shot of a similar hydroboost setup to what I'm running and a LINK to some info on them:
Hydroboost brakes beat the snot out of vacuum assist brakes for a great many reasons, and with a cammed motor like mine, they are even more important for good consistent braking over a large rpm range. My hydroboost is on the way and came out of a 2008 GMC Sierra 3500 truck, what can I say, it fits the theme of the build. Also, upgrading the size of all the brakes on the VX makes this a must have mod. Here are a couple pics of said brakes.
The first pic is of the rear calipers which are factory rebuilt with new ceramic pads and painted with caliper paint. The second pic is of the front D60 caliper which I had to wire-wheel and strip of all of the paint and crud, then paint. The third pic is of a 14 bolt wheel hub I had to strip down and paint, then press in new wheel studs and brake rotor. Here's what these used to look like:
Reply With Quote
Originally Posted by LittleBeast
.
