These would be sweet on that front 60...50 degrees of steering!
I would have already bought those because they are priced around the same as upgrading to forged inner C's and knuckles, but the spidertrax setup requires two unit bearings at an additional cost of $740!!! Unit bearings are also not servicable, only replaceable, so if one goes out, so does your wallet I was thinking more along the lines of this for 50 degree steering:



For $300 for the whole set, not too bad. I could also use the opportunity to upgrade to alloy alxles. This nice part is that they retain the maunfacturers warranty!!


Just wondering mate when your done can you come over here and do mine
Yeah, shoot me a plane ticket and put me up, and I'll do it.