Veddy niiice! How's your back? Is that combo around 120 lbs or so?
Close, 116.5 including the centramatics and all the nuts holding the wheels together. This is without the inner beadlock portions which I'm estimating at 7-12 lbs. So we are looking at close to 130 a piece. In answer to your question though, they sucked to move upstairs in the heat, so I was a little sore and a lot tired Moving them back down should be fun though

Dude, that setup looks NASTY. So, where are you at with the project percentage wise? 50% done? 75%? Almost there?
I would honestly say 45% realistically. I don't really feel like I'm quite over the hump yet. I have a lot of what I need, so probably not a lot of waiting for parts, but I need a plasma cutter something fierce right now, but can't bring myself to justify the cost for how much I'll be using it. Maybe I should "borrow" the one from the facility for the day Other than that, there is just a lot of ancillary things to do like get a hold of sensors for the engine and stuff. The order of things is a mess too, it's always take things apart, put them back on for a test fit, take them off cause they're in the way, wash ,rinse, repeat. I have to take the rims out to guard to sandblast them, then order the powder, then shoot them and bake them. Also have to order the 16" o-rings they take and I'd like to scare up some new hardware for holding them together since the current stuff looks a bit I may even go really hardcore and drill some safety wire holes for the nuts.