factory wheel question

[etlsport]

mounted them... the offset is more than i was anticipating.. had to cut a good chunk off the front of the wheel well and looks like i will have to cut the back of the well too.. any tips on where/how to cut it?

thinking may just do a 1" coil spacer and crank the torsion bars to help too

[Mile High VX]

I took the "bolt" at the corner of the cladding out and with some help from a large hammer made the needed adjustment. I did not cut the rear.

If you take the inner fender loose you will see that there is about a 3/4" spacer that holds the cladding out from the fender well. My original thought was to cut that spacer out and then put it back together. Thankfully the hammer was enough.

My wheels are +6 offset with 275/60/18's.

[Ldub]

mounted them... the offset is more than i was anticipating.. had to cut a good chunk off the front of the wheel well and looks like i will have to cut the back of the well too.. any tips on where/how to cut it?

thinking may just do a 1" coil spacer and crank the torsion bars to help too

And you're gonna post pics WHEN???...

Those be some good lookin' wheels Eric, let's see em ON!...

[etlsport]

sorry for the delay! this is the only pic ive got since its been awful out the last two days, ill try for some good pics today.. still a bit of rubbing in the rear of the well, but ive got a few hours tomorrow morning so hopefully i can take care of it then