Results 1 to 4 of 4

Thread: Scan tool

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Member Since
    Dec 2008
    Location
    98. Blazed Peacock Mica, 1504 SOLD VxLess Now :O
    Posts
    423
    Thanked: 0
    Sweet glad you found 1 .

    good luck with finding the problem etc

  2. #2
    Member Since
    Mar 2012
    Location
    1997 Silver VX
    Posts
    15
    Thanked: 0
    I was just reading some old posts and found this one.

    VX-157 did you ever get to the bottom of the TOD code 13 problem?

    I have the same problem on my JDM. I have tried the TOD computer from my spare car but it didn't fix the problem. I also took the TOD transmission out of the spare car and connected the plugs to my registered car and connected it electrically and the fault remained. Not sure where to go from here, have started looking at the wheel sensors but they look ok. Will try swapping the sensors between the cars next, any other ideas would be appreciated.

    I can read the codes and reset them using the manual method and shorting pin 8 to ground on the OBDII connector.

Similar Threads

  1. Permission to scan VX-O2 granted by Isuzu
    By Baldwin in forum VX Talk...
    Replies: 34
    Last Post: 09/11/2012, 12:16 PM
  2. Scan Gauge issue
    By JHarris1385 in forum Chit-Chat ...
    Replies: 7
    Last Post: 04/08/2010, 11:29 AM
  3. SCAN Gauge II
    By JHarris1385 in forum General Tips...
    Replies: 7
    Last Post: 01/09/2007, 05:08 PM
  4. Scan Gauge to get out of a ticket?
    By etlsport in forum VX Talk...
    Replies: 25
    Last Post: 07/08/2006, 03:08 PM
  5. Scan Gauge
    By cascabel3 in forum VX Modifications...
    Replies: 5
    Last Post: 04/01/2005, 03:12 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
$lv_vb_eventforums_eventdetails