Results 1 to 15 of 21

Thread: front end problems

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Member Since
    Feb 2006
    Location
    2001,Kaiser Silver, VX, 0563
    Posts
    4,767
    Thanked: 0

    front end problems

    been noticing a clunk from the front end of the VX recently, mostly on back roads when im doing 40-50, braking hard into a turn and then accelerating through the turn i hear a clunk from the front of the VX

    put it up on a lift yesterday and noticed theres about 1/8" of play in both front CV shafts, and probably a full 1" of play in the shaft between the front diff and the transfer case

    has anyone else had problems in that area, im still trying to figure out where the problem is actually coming from, the transfer case or the front diff

    the shaft between them does not move up and down, but i can turn it by hand quite a bit

    the inner cups on the cv shaft move just a bit, the guy looking at it with me didnt seem concerned about that at all, just the play in the front drive shaft

  2. #2
    Member Since
    Jan 2009
    Location
    97 Jap Import, Black BEAST
    Posts
    1,515
    Thanked: 0
    is this dropping from 3rd to 2nd as you put the power back on???? if so i have experienced the problem
    Speed Thrills, Boredom Kills!!

  3. #3
    Member Since
    Jan 2008
    Location
    1999 Astral Silver 0481
    Posts
    2,672
    Thanked: 0

    Question

    Probably the play has to be due wear/age eric.

    Anyways if the mech had no concern after looking at the shafts then it couldn't be that serious.

    Only thing that pops up on my mind is have them replaced.
    Dakar was just the begining.

  4. #4
    Quote Originally Posted by etlsport View Post
    been noticing a clunk from the front end of the VX recently, mostly on back roads when im doing 40-50, braking hard into a turn and then accelerating through the turn i hear a clunk from the front of the VX

    put it up on a lift yesterday and noticed theres about 1/8" of play in both front CV shafts, and probably a full 1" of play in the shaft between the front diff and the transfer case

    has anyone else had problems in that area, im still trying to figure out where the problem is actually coming from, the transfer case or the front diff

    the shaft between them does not move up and down, but i can turn it by hand quite a bit

    the inner cups on the cv shaft move just a bit, the guy looking at it with me didnt seem concerned about that at all, just the play in the front drive shaft
    Check the rear tranny mount make sure you didnt rattle the nuts loose or off the two in the middle........Might have to take rear skid plate down but do check that, Had this prob once cause i live off a dirt road that is wash board, I noticed a strange knock in the front just thought it was a shock that needed wrenching but sure enough the tranny bolts got loose.

  5. #5
    Member Since
    Jun 2002
    Location
    1999, Ebony, VX, #1679
    Posts
    8,422
    Thanked: 3
    Those tranny mount bolts seem to work loose for many, myself included. I recommend EVERYONE check theirs.
    Billy Oliver
    15xIronman
    My Sponsors:
    Accelerate3Coaching
    TriSports.com (PM me for 1 time use 20% off code)

  6. #6
    Member Since
    Feb 2006
    Location
    2001,Kaiser Silver, VX, 0563
    Posts
    4,767
    Thanked: 0
    i did just start driving through some REALLY crappy streets lately.. its very possible. where are these bolts located? near the cross member? ill probably try to get it up in the air this morning and look

  7. #7
    Quote Originally Posted by etlsport View Post
    i did just start driving through some REALLY crappy streets lately.. its very possible. where are these bolts located? near the cross member? ill probably try to get it up in the air this morning and look
    Directly in the middle of the rear cross beam!! Two of them about three inchs apart, Your tranny is directly over the top and is bolted to this or at least it should be.

  8. #8
    Member Since
    Jan 2009
    Location
    1999, Ebony Black, VX, 1614
    Posts
    1,852
    Thanked: 1
    Looks like I am going to need to do this.

    I have been looking through this thread and THIS ONE. I have just a couple questions.

    What size bolts?
    Where do I get them from?
    How tight do I tighten them? (I dont have a torque wrench)
    Any other suggestions or ideas?

    Thanks!

Similar Threads

  1. TOD Problems
    By Benny in forum VX Troubleshooting...
    Replies: 4
    Last Post: 02/05/2014, 12:15 PM
  2. Replies: 9
    Last Post: 02/02/2013, 07:42 PM
  3. PS3 problems
    By Triathlete in forum Chit-Chat ...
    Replies: 12
    Last Post: 02/07/2011, 05:18 PM
  4. front axle problems
    By bigkoala1 in forum VX Troubleshooting...
    Replies: 14
    Last Post: 01/24/2011, 02:43 AM
  5. RPM Problems
    By sintex420 in forum VX Troubleshooting...
    Replies: 20
    Last Post: 10/07/2003, 04:31 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
$lv_vb_eventforums_eventdetails