Results 1 to 7 of 7

Thread: Gawd, not another Roof Rack Post...

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #7
    Member Since
    Jun 2007
    Location
    2001, Proton
    Posts
    3,299
    Thanked: 0

    guaranteed to fit VX

    Quote Originally Posted by BoarderCROSS2000 View Post
    Sorry Folks, I hafta.

    As the snow approaches Tahoe, I've been getting more and more frustrated with the general gloom and doom of the unavailability of the VX Roof Rack. I simply don't have the patience to wait til another owner wrecks and besides that's morbid anyway.

    Just as I was about to try the goofy cheapo magnet supports from INNO, I searched yet again in the archives and came across this post from 2007

    Best non-factory rack I've found
    Sorry, couldn't find my part numbers, but here's a link to the towers; the Yak Lowrider is the lowest tower I've found.

    http://www.yakima.com/Product.aspx?id=144

    Buy a set of four towers. The towers are very easy to install and fit right in the stock placements on our factory rails. Simply pop off the four covers on the factor rails and hand tighten the towers into position. You'll notice that the "hook" on the towers fits right into the rail indents. Very sweet.

    You'll also need two Yak cross bars. 48" is the shortest Yak makes and don't overhang the VX too badly (the standard Yak cross bars are round vs the oval cross-bars that came with the factory rack). You could trim these down (shorten) with a hacksaw if you wanted, but I think they look OK.

    I'd also recommend you pick-up a Yak SKS four-lock set and put a lock on each tower. Around here, if your rack isn't locked on, its gone. Maybe a six or eight-lock set if you plan on adding accessories (I needed two more; one each for the ski carriers on each cross-bar).

    Finally, take a 10-minute drive on any bumpy street road and then re-tighten the towers by hand; you'd be amazed at how much more you can tighten them (I got two full turns).

    Best,
    __________________


    Jim

    ZUtah Wheeler


    Good Gawd... is it this easy? Just getting a gutter mount tower is all it takes? I appreciate that this might look a little hinky, but it should hold my ski racks right? If this is indeed true, Is there a concensus as to quality? Thule or Yakima? Yakima seems to sell the A1 Guttermount towers and I can't find anything current about the LowRiders mentioned above...

    Thoughts?

    Thanks,

    Jeff
    Comes in various colors
    Last edited by circmand : 11/03/2009 at 10:02 AM

Similar Threads

  1. roof rack
    By Norrin Radd in forum VX Modifications...
    Replies: 2
    Last Post: 04/29/2014, 09:11 PM
  2. Yakima roof rack clearance with sliding roof?
    By JULIAN911 in forum Ldub's After Midnight Topics
    Replies: 2
    Last Post: 03/21/2014, 01:35 PM
  3. Roof Rack Mod
    By nfpgasmask in forum VX Modifications...
    Replies: 18
    Last Post: 07/10/2007, 08:51 PM
  4. Want Roof Rack
    By disasterlady in forum VX Troubleshooting...
    Replies: 12
    Last Post: 01/05/2007, 04:28 PM
  5. Replies: 7
    Last Post: 06/09/2005, 02:39 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
$lv_vb_eventforums_eventdetails