front end problems

[Triathlete]

Those tranny mount bolts seem to work loose for many, myself included. I recommend EVERYONE check theirs.

[etlsport]

i did just start driving through some REALLY crappy streets lately.. its very possible. where are these bolts located? near the cross member? ill probably try to get it up in the air this morning and look

[SBC]

i did just start driving through some REALLY crappy streets lately.. its very possible. where are these bolts located? near the cross member? ill probably try to get it up in the air this morning and look

Directly in the middle of the rear cross beam!! Two of them about three inchs apart, Your tranny is directly over the top and is bolted to this or at least it should be.

[JAMAS]

Looks like I am going to need to do this.

I have been looking through this thread and THIS ONE. I have just a couple questions.

What size bolts?
Where do I get them from?
How tight do I tighten them? (I dont have a torque wrench)
Any other suggestions or ideas?

Thanks!

[tom4bren]

How tight do I tighten them?

Turn clockwise

If you have to replace missing bolts, don't forget to put some locktite on them when you install the new.

[JAMAS]

How tight? Not, how do I tighten them...

I'm not THAT bad of a mechanic.....but close

I will definitely use loc-tite, thanks!

[tom4bren]

How tight? Not, how do I tighten them...

I'm not THAT bad of a mechanic.....but close

I will definitely use loc-tite, thanks!

Sorry, musta still had that mental image of you in a dunce cap sitting in the corner.

Look here:

http://www.vehicross.info/forums/sho...mmended+torque