Repainting windshield wipers (not the blades)

[handeeman]

The key thing to do beforehand is to take a felt-tip Magic Marker Pen and make a mark on the head of the mounting pin (male end) and edge of hole on wiper arm (female end) so that it's easy re-mount the wiper arms perfectly back in the original position(s).

In addition, you can also take a piece of masking tape and tape along the edge of the rubber blade wear it touches the glass windshield before removal. In this way, when the arms are re-attached then you'll know that they are re-installed in perfect original alignment.

That's what I was trying to remember, to get it back right. Thanks Riff.

[VX-13]

After reading and now know how to take the blade arms off I'm going to powder coat them this afternoon and I'll post some before and after pics thanks for the tips guys

[Ldub]

I did this about a month ago, & found that they don't exactly slip right off after being on for ten years...

I pressed a 2 jaw puller into service, that was designed for tie rods/pulleys etc.(read: too big)
Since then, I picked up a smaller 2 jaw puller from O'Reilleys for around $10.-.
It'll fit way better next time.

Mine weren't rusty, but I scuffed em' up real good with a scotchbrite pad, then cleaned them with 90% rubbing alcohol.

A coulpe coats of primer, & a few coats of satin black...BAM, look new!...

http://vehicross.info/forums/showpos...&postcount=185

[VX crazy]

I did this too years ago on my other VX but I used the hammered grey, looks better than flat black.....need to do the current VX too.....awww another project!

[Solitude]

I painted mine about 2 years ago.. I just taped the wipers off and painted them on the vehicle.

When you tape off.. you use masking tape and news paper and cover the car within about 3 feet of the blade.. on all sides.. and do not use the mil-spec rule.. the bigger the glob the better the job

good luck
p.s. I couldn't get my arms off the vx either so figured this wasn't an impossible way to go

[dietz99vcross]

I did mine about two years ago and they came right off without any difficulty. I went with a matte black after a light sanding and they still look good.

[lasturbo]

I painted mine last year with a Rust-Oleum Professional flat black paint. I prepped them with a Scotch Brite Pad (Very Fine-Type A red pad) and they look great!!