VX Shop Manual 2A-48
Page 219
You will need a steering wheel removal tool. I got mine a Pep Boys (Kragen and O'Reilly's has them too for about 15 bucks)
Here is the verbiage:

Removal
1.Turn the steering wheel so that the vehicle’s wheels
are pointing straight ahead.
2.Turn the ignition switch to “LOCK”.
3. Disconnect the battery “–” terminal cable, and wait at
least 5 minutes.
4. Disconnect the yellow 3-way SRS connector located
under the steering column.
5. Loosen the inflator module fixing bolt from behind the
steering wheel assembly using a TORX) driver or
equivalent until the inflator module can be released
from steering assembly.
6. Disconnect the yellow 2-way SRS connector located
behind the inflator module.
WARNING: THE INFLATOR MODULE SHOULD
ALWAYS BE CARRIED WITH THE URETHANE
COVER AWAY FROM YOUR BODY AND SHOULD
ALWAYS BE LAID ON A FLAT SURFACE WITH THE
URETHANE SIDE UP. THIS IS NECESSARY
BECAUSE A FREE SPACE IS PROVIDED TO ALLOW
THE AIR CUSHION TO EXPAND IN THE UNLIKELY
EVENT OF ACCIDENTAL DEPLOYMENT.
OTHERWISE, PERSONAL INJURY MAY RESULT.
7. Remove steering wheel fixing nut.
8. Apply a setting mark (1) across the steering wheel
and shaft so parts can be reassembled in their original
position, then remove steering wheel.
9. Move the front wheels to the straight ahead position,
then use steering wheel remover J–29752 to remove
the steering wheel.
CAUTION: Never apply force to the steering wheel
in direction of the shaft by using a hammer or other
impact tools in an attempt to remove the steering
wheel. The steering shaft is designed as an energy
absorbing unit.
Installation
1. Install steering wheel by aligning the setting marks
made when removing.
CAUTION: Never apply force to the steering wheel
in direction of the shaft by using a hammer or other
impact tools in an attempt to remove the steering
wheel. The steering shaft is designed as an energy
absorbing unit.
2.Tighten the steering wheel fixing nut to the specified
torque.
Torque: 34 N·m (25 lb ft)
3. Connect horn lead.
4. Support the module and carefully connect the module
connector.
CAUTION: Never use the air bag assembly from
another vehicle. Use only the air bag assembly for
“VX”.
NOTE: Pass the lead wire through the tabs on the plastic
cover (wire protector) of inflator to prevent lead wire from
being pinches.
5.Tighten bolts to specified sequence as illustrated.
Torque: 8.8 N·m (78 lb in)
6. Connect the yellow 3-way SRS connector located
under the steering column.
7. Connect the battery “–” terminal cable.
8.Turn the ignition switch to “ON” while watching
warning light. Light should flash 7 times and then go
off. If lamp does not operate correctly, refer to
Restraints section.