brunton compass custom install - first mod as a new VX owner!

[ryandesigns]

with a little dremel work the useless compartment worked out really well for the compass. it looks like it belongs stock.

calibration is going to take a little time, I got it close but I think I'll wait until my next excursion to dial it in just right.

[Scott Harness]

That looks great!

[Travelin2]

Now you are set for cross country.

[Marlin]

Hmmm, did you know that all new GPS units have a built in compass....

Welcome to the addiction.

[kirk hilton]

That looks a great little mod. I've wanted to made a similar mod to the compartment but I failed to pop it out of the dash (which just flexes if I just pull) is the a knack to removing it?

[ryandesigns]

I popped mine out by mistake, try pulling toward the steering wheel while your pulling out on it.

[ryandesigns]

I want GPS with a compass too! but this will still be useful when the satellites go offline or otherwise become unavailable to the public ...I'm half joking but we take a lot for granted with technology.

[TheGanzman]

Nice work! Did you use the Brunton #58CE Illuminated model, and if so, what did you power it from?

[Triathlete]

I want GPS with a compass too! but this will still be useful when the satellites go offline or otherwise become unavailable to the public ...I'm half joking but we take a lot for granted with technology.

Theres always the sun...for billions of years it has risen in the east and gone down in the west!

[Scott Harness]

Theres always the sun...for billions of years it has risen in the east and gone down in the west!

x2 LOL

[ryandesigns]

its is and I'm actually finishing the install now, I hooked it in behind the fuses with the cig lighter but I really only want it on with my dash lights... any ideas?

[etlsport]

if you remove the ash tray, there is a light above it that only lights up with the headlights, try tapping that wire... very nice install though!

[Marlin]

if you remove the ash tray, there is a light above it that only lights up with the headlights, try tapping that wire... very nice install though!

I don't think that is entirely true. I think there is also a limit switch that it only lights up when the ash tray is open. I took my ashtray out and mounted my scan gage there. I had to disconnect the bulb cause it was always on.