TOD Check Light On JDV VX

[VX-157]

hi mate, i can only suggest that you get under your front end and have a look at your front diff. you want to check that your sensor plugs have a good connection. you have been in mudd and krudd latly so you may given this a bit of a knock.

All i got sorry

(on a side note, i did loose my 4wd to my front diff a little while ago, turned out to be a crushed vucumm hose. though it did not affect my tod display)

[VehiGAZ]

I have had the ToD check light come on twice, and both times it was because the sensor wiring harness had grounded out somewhere - the first time the harness melted on the cats after a clip broke, the second time it was just doe to wear where the harness passed through a hold in the frame somewhere underneath.

Good luck!

[crotchrocket]

hi mate, i can only suggest that you get under your front end and have a look at your front diff. you want to check that your sensor plugs have a good connection. you have been in mudd and krudd latly so you may given this a bit of a knock.

All i got sorry

(on a side note, i did loose my 4wd to my front diff a little while ago, turned out to be a crushed vucumm hose. though it did not affect my tod display)

I am confused by the mension of vacume hoses?? i saw someone else mension it too. I thought the system was fully electronic?? The electromagnetic clutch simply engages the front wheels to a degree depending on road conditions which are fed to it from front and rear prop speed sensors, TPS sensor and brake sensor?

When in Low range the clutch is bypassed by a drive chain.

[crotchrocket]

OH, and thanks to the site for all the info available and the TOD info downloads!!!!! Thought i'd pop $10 into the donations bucket for the privelage