Dougie, depending on how big you go with your tires, and if you lift or not, you may end up cutting off even less of the cladding than is shown in the picture. When I was stock height and installed the Terra Grappler 285/60/18's I had to trim off just a tiny corner of the cladding, and that corner was just the tip of the cladding that sticks into the front of the wheel well. I didn't have to cut anywhere near the exterior lip of the cladding so unless I'm parked right next to an unaltered VX AND you stick your head into the wheel well and look at the front corner of the wheel well you would never know anything was removed. I ended up using a Dremel tool with a cut-off wheel to trim the cladding then used some sand paper to smooth everything out for a factory look.
"The major difference between a thing that might go wrong and a thing that cannot possibly go wrong is that when a thing that cannot possibly go wrong goes wrong, it usually turns out to be impossible to get at or repair."
-Douglas Adams, Mostly Harmless
Reply With Quote
Originally Posted by MSHardeman
...who told YOU?...
