Your sweet plywood intake reminded me...Originally Posted by Robbomaz
Heres the SC on our chassis. Note the high tech plywood manifold!
Rob
I'm just throwi'n this out there as food for "you know what"...
I haven't looked at my stock intake plenum in years, but remember the top & bottom halves come apart...
Would it be possible to utilize the bottom half of the stock intake, to connect to the intake ports on the heads, & fabricate/machine a flat plate to seal the top, that the S/C would be attached to? I was thinking 1/2" aluminium plate.
Like i said, it's been years, so I've probably overlooked a detail or two, but I always thought that this might be an improvement over the cast iron intake lump that I originally received from Alpine.
Reply With Quote