Results 1 to 9 of 9

Thread: did i push my VX too hard?

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Member Since
    Jan 2009
    Location
    97 Jap Import, Black BEAST
    Posts
    1,515
    Thanked: 0
    Quote Originally Posted by etlsport View Post
    well i noticed not too long ago my antifreeze level had dropped a bit.. not a huge amount, but some.. also noticed wetness on the inner fender well.. so i figured thats where the coolant went

    i went to get my coolant flushed and re-filled and the mechanic tells me that when pressure tested, my radiator lost 4lbs of pressure over 5 minutes and then held steady at 9psi, but that he couldnt do a radiator flush if my radiator was leaking

    we looked high and low for a leak, didnt see anything obvious, he asked if id seen any white smoke.. i hadnt, he checked the oil, said it looked alright (ie no obvious signs of coolant in it)

    did quite a bit of work on the VX today including an oil change, oil looked pretty clear (for dirty oil) not murky or anything, kinda like coke

    started and stopped the VX many times while i was working on it.. and started to notice that on startup i was getting thin white smoke from the exhaust... yikes... im HOPING that the white smoke was condensation since the temp went from 30-65-30 here today and i was doing all the work during the cooldown period...

    does this sound like it could be a blown headgasket? and if so.. well what are my options, i know its gonna cost a whole lot to have a dealership fix it.. how realistic is it for me to attempt that repair myself? ive done a good amount of work, but have zero experience inside an engine

    did you actually take it for a run or just start it on the drive? Think you may be acting a little early. If its leaking oil into the engine you'll definately know about it, it will smoke when hot + cold.

    Sounds like condensation. I get it everyday here.
    Speed Thrills, Boredom Kills!!

  2. #2
    Member Since
    Jun 2005
    Location
    01 Dragon Green VX 1286
    Posts
    423
    Thanked: 0
    I have a small water leak that drains right down the middle left (DS) of the oil pan. that might be a place to look

  3. #3
    Member Since
    Feb 2007
    Location
    2000 Proton VX - 0776
    Posts
    9,258
    Thanked: 0
    Eric,

    Don't start losing any sleep yet. Even if you are getting some coolant into the cylendars it shouldn't cause any damage. If it were getting into the oil, then you would need to worry.

    Tom
    [SIGPIC][/SIGPIC]

    Put a smiley after you say that Bub.

  4. #4
    Member Since
    May 2006
    Location
    SOLD!
    Posts
    7,257
    Thanked: 2
    Well, my VX has been leaking coolant like a mo-fo for the last 2 months. I ordered all the timing belt stuff and I am going to change the water pump and radiator hoses, and clean the radiator. I hope this stops the coolant leak. I have been leaking coolant for a long time (most likely from the o-ring place) but over the last 2 months my coolant leak has gotten WAY worse.

    My coolant level drops considerably over time and I have to keep it full, but I have yet to have any overheating. Tonight I change the oil and top off the coolant. I'm still waiting for the timing belt parts.

    Bart

  5. #5
    Member Since
    Jun 2002
    Location
    2001 Ebony S/C #1304
    Posts
    3,647
    Thanked: 10
    +1

    Mine has pretty much ALWAYS been low on coolant. The radiator level is fine, but my overflow is always near empty. Only time I overheated was when I had bubbles in the line. I really wouldn't be too concerned with it right now, but I do understand your concern over, "where is it going?" On occasion, I actually find a small trickle of greenish fluid right on top of the radiator near the cap. No little in fact that I just look the other way.
    Gary Noonan
    '01 S/C VX / '18 Forester XT

Similar Threads

  1. Push Bar
    By Hiredgoon in forum VX Modifications...
    Replies: 26
    Last Post: 02/03/2011, 01:16 PM
  2. Hard to believe...
    By nfpgasmask in forum VX Talk...
    Replies: 41
    Last Post: 10/24/2007, 06:10 PM
  3. push bar and side steps(nerfbars)
    By drummysvx in forum VX Talk...
    Replies: 13
    Last Post: 07/19/2007, 11:00 AM
  4. Push button ignition
    By jkstephens83 in forum VX Modifications...
    Replies: 2
    Last Post: 06/19/2007, 01:58 PM
  5. Hard Shifting on the 2-3
    By Joe C in forum VX Talk...
    Replies: 4
    Last Post: 08/13/2003, 01:34 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
$lv_vb_eventforums_eventdetails