Help! Window won't work after bracket installed...ideas?

[VX KAT]

Had my SBC brackets installed Tuesday, let them cure for 2 days. Just tried them for 1st time. Driver side OK, but Pass side seems dead, no clicking, no noise, no nothing like there's no power.

LOCK button DOES work however, so it appears window motor unit is getting juice?

Took off door panel. I can't get the white lego looking connector with the wires to pull apart from the handle unit. Shouldn't be that hard???

Any ideas??

[rowhard]

Took off door panel. I can't get the white lego looking connector with the wires to pull apart from the handle unit. Shouldn't be that hard???

Any ideas??

any chance it was forced on 180 out

[VX KAT]

it crossed my mind that it may be on reversed 180 degrees, but I wouldn't think the lock would work...

[rowhard]

it would with a big enough hammer, or mechanics hand. The handle is easy enough to pop off to check. You are flipping the locking tab right?

[VX KAT]

I did finally see the lock tab and got it to come off. Everything "looks" Ok, all the male pins looked OK. I heard a nice solid click when I put it back in....but still dead. Lock still works. Maybe some of the wires are damaged on that small harness. I can't see anything obvious.

If the window motor is fried, would the locks go too?

What about fuses, is there a fuse for this or would BOTH windows be dead if it was a fuse?

[etlsport]

ok dont get mad for this suggestion... but if you havent tried it already... check to make sure the window controls arent locked on the drivers side door handle.. theres button next to the lock button that will disable the passenger side window.. double check that

if that doesnt do it.. check the harness to the drivers side handle, i know all of the wiring runs through there first