Anyone else have input on my post? boo-hoo.....


Quote Originally Posted by VX4EJR View Post
Searched high and low on here and couldn't find the info on this...

When installing the front (energy suspension) greaseable bushings, where "should" the slit in the bushing itself face? There are two ways, facing down or facing up?
Problem I'm seeing is when I installed them facing up and then putting the brackets on, positioning, tightening, etc, done...the outer facing area of the slit (beyond under the metal bracket) does not close up or meet all the way on both fronts and I end up with a small but noticeable gap up there on the bushings. I tried putting them in facing down and the slit closes up tight on both front bushings. I don't know, maybe nothing of any concern but thought I'd see if anyone else experienced this and what the preferred install was? The back ones were no problem at all.