Post of all Rims and Tires out there!

[VX KAT]

I had -2 offset on my Borbets and 265/60-18s with stock height, no lift.....and quite a bit of trimming. Had to pound the rear part of the front wheel well and pound back the bolt there....and cut out most of the fender liner, and they stuck out about 1/2" from the wheel well. With a -10 you're looking at at least the same amount of trimming and sticking out even further.

[jonnybegood]

I had -2 offset on my Borbets and 265/60-18s with stock height, no lift.....and quite a bit of trimming. Had to pound the rear part of the front wheel well and pound back the bolt there....and cut out most of the fender liner, and they stuck out about 1/2" from the wheel well. With a -10 you're looking at at least the same amount of trimming and sticking out even further.

Good to know. I cringe when I think about BFH'n the rear of the front fender but maybe it's not too bad...? They also make a 16X8 with 0 offset and 4.5"BS. according to 1010tires offset calculator the 16" wheel will stick out 51mm more than the stock 18" that I'm running now. These SCS wheels look so good i just don't know if it's worth it.