when having to "trim".. what tool are you guys using..
looks like some rough edges in some pics..
any advice to reduce the rough look?
thanks
Haggis
'Zoid
when having to "trim".. what tool are you guys using..
looks like some rough edges in some pics..
any advice to reduce the rough look?
thanks
Haggis
Super VXer
i was gonna use a router i think that call it ? lol i just know the tool by sight its like a little drill that you can put attachments on. prob use that to cut mine or ill find something else.
Super VXer
Haggis,
When I trimmed my cladding for my tires I used a Dremmel tool with a cut off wheel attached to it. After the initial cut I used some sandpaper to smooth out and ease the edges for a "stock" look. If you didn't know it, you would never know that the cladding has been trimmed.
"The major difference between a thing that might go wrong and a thing that cannot possibly go wrong is that when a thing that cannot possibly go wrong goes wrong, it usually turns out to be impossible to get at or repair."
-Douglas Adams, Mostly Harmless
Super VXer
Ended up using a air hacksaw thing. did the job was easeon the front now just have to do the back bits of the wells.
Posting Permissions
Reply With Quote