Fun With LEDs! Part II

[Knigh7s]

ooo looks nice!

btw, do you use a resistor pack or anything when doing this? I dropped in an 194 wedge LED into my license plate lights and it blew my brake light fuse

[Kenny]

Resistors?
Yup. You need em.
Soldered on a resistor at the head of the red string of LED; somewhere around the 700 Ohm. And a ~2K Ohm on the two clear LEDs.

Did I mention how much I hate soldering?

(The PIAAs were plug and play fogs.)

[Knigh7s]

Resistors?
Yup. You need em.
Soldered on a resistor at the head of the red string of LED; somewhere around the 700 Ohm. And a ~2K Ohm on the two clear LEDs.

Did I mention how much I hate soldering?

(The PIAAs were plug and play fogs.)

Yes you did! LoL - I kinda like soldering, sept when you're in the middle of something and you set the iron down on the table instead of in the holder, to go reach for it in the holder and realize you just burnt the shii out of something you are working on.... Or does that only happen to me! LOL

I'll figure it out someday. I found a LED resistor Calc online... just need to learn how to use it the right way!

[Gussie2000]

Holy s...

It's a invasion ship mami

Looks very good though !

Can you make a write up about how to do it step by step. ?

[tom4bren]

"you just burnt the shii out of something you are working on.... Or does that only happen to me!"

Nope, you're not alone. I was soldering a stained glass thinggy for wifey a while back - so much solder on those things - a big drip landed just south of ground zero.

It's always fun too when you're using shrink tubing and it slides down near the solder joint before you're ready - *&^%*&^

BTW Kenny - didn't mean to jack your thread. Your lights look great & I agree that the white will be much better than the red.

[Ldub]

ME LIKEY . . .

[mdwyer]

Nope, you're not alone. I was soldering a stained glass thinggy for wifey a while back - so much solder on those things - a big drip landed just south of ground zero.

It's always fun too when you're using shrink tubing and it slides down near the solder joint before you're ready - *&^%*&^

Luckily, solder doesn't hold a lot of heat. Give me solder splatters over a dose of high-temp hotglue ANY DAY.

This from the guy who has a rain jacket full of holes because he couldn't control his soldering iron.

Anyway, I like the effect on the lights. Looks pretty decent.

[WormGod]

Looks like the Disney Parade. A bit too colorful for my taste, but nice job.