uploading the video now to youtube.. but i have to run to work in like 15 minutes and its not done uploading.. ill try to post the link to the video later but if you dont want to wait that long try searching youtube for "vehicross zerk"

I have no idea what happened to my grease gun in the move, so the video just shows the zerk fittings on the u joints and the drive shaft

what you would do is buy a grease gun with a flexible hose at least 12" (i had to buy them separate) buy some grease to put in it, it comes in a cardboard tube, i used mobil 1 synthetic grease.. load up the tube into your grease gun according to the instructions

get under the vx and locate your zerk fittings.. if you cant find them, roll the vx forward about 1 foot and check again (dont forget to put it in park and set your parking brake!!!)

push the tip of the grease gun squarely onto the zerk fitting.. start pumping grease in! if you see grease coming out from around the fitting, make sure the grease gun is pushed all the way on and try again, pump grease until the grease you see start to come out of the middle of the u joints looks clean (you will hear it and see it come out after 5-6 pumps)
the fitting in the middle, the grease will come out where the driveshaft changes sizes, youll see it