Not too bad...

Had an extra set of hands and it went a long way...

Full can of cutting oil, constant stream during the drilling process.

Start to finish was about 2.5 hours, and that's including a stop to eat lunch.

One recommendation I have to ad is:
If you put on the bumper cover and you have to have anyone hold it in place while you put in screws, you need to shave a bit more from your hitch cut out.

Mine was off by 1/8" on a couple holes, I had someone hold it flexed in place whiles I screwed on the cover. Unfortunately when I got to the VERY VERY last hole (right next to the hitch) There was no more flexing and it didn't line up.

So I've got one screw missing from my cladding Going to mentally bother me, but no one would ever know. (If I hadn't just posted it for the world to se)


Only took 1 Bit, and 1 can of cutting oil.