Skid Plate Fabbrication

[Marlin]

WTB someone to hit enter after every picture so everyone doesnt have to scroll right on every comment.. Just some advice



For example post picture hit enter a few times then rinse repeat if you are adding more than one picture

Thanks to whoever fixed my post You only have to tell me wonce, I am a quick lurner...if I could only lurn to spell.

[Dumke]

Thanks to whoever fixed my post You only have to tell me wonce, I am a quick lurner...if I could only lurn to spell.

Well I need a speller checker so if someone helps me with that then we are both golden...


And sorry you are not the only one I just thought would say it in that post lol..

[pbkid]

very nice!! you are gonna be ready to WHEEEEEEEEEEEL!!!

[Dumke]

Oh yeah btw forgot to say NICE job.

[Marlin]

Here is plate #2, and I think it will be the last plate, the transfer case is covered by the trooper plate, and there isn't a whole lot else in the rear except the differential. The gas tank already has a plate. So I believe I am done.

[Triathlete]

Might want to overlap the front plate over the rear (looks like the rear is over the front) to prevent it from snagging on rocks. Looks good though.

[Riff Raff]

Might want to overlap the front plate over the rear (looks like the rear is over the front) to prevent it from snagging on rocks. Looks good though.

TRIATHLETE--- Hmmm, good point. However, I suspect MARLIN considered this, but probably ran into some kind of engineering dilema that prevented him from overlapping the front over the back as you mentioned. In the event the plate does get "snagged" on a rock, them just Hammer Down!!! I do agree, that MARLIN has done a very impressive job; especially for not having any formal metal fab training and for also doing all of his mod's in his frickin' driveway. Simply incredible!!!

[Marlin]

Might want to overlap the front plate over the rear (looks like the rear is over the front) to prevent it from snagging on rocks. Looks good though.

Actually, the rear is over the front with a two inch overlap, but only in the center 10". It doesn't look like it in the pic though...
Thanks for the bid of confidence Riffraff. It did come out nice. Now I have half a sheet of diamond deck, gotta think of something to do with it. Maybe a base for the luggage rack?

[Travelin2]

Well I need a speller checker so if someone helps me with that then we are both golden...


And sorry you are not the only one I just thought would say it in that post lol..

Dumke; I use this for an image resizer in Vista. Its' only a little over 2 MB. They may have a spell checker too.


http://www.powerhourgame.com/windows...ge_resizer.htm