Looks like initial price for fab/materials is going to be in the 300 - 400 range for me. I asked about aluminum vs diamond plate cost. Difference is small, so I will go with diamond plate. I will keep you updated once fabbing starts.
James
Super VXer
Looks like initial price for fab/materials is going to be in the 300 - 400 range for me. I asked about aluminum vs diamond plate cost. Difference is small, so I will go with diamond plate. I will keep you updated once fabbing starts.
James
[SIGPIC][/SIGPIC]
I have a Sith sense....I see Darth people...
Super VXer
man, i want a set...
VXer in the Sky
I have plans for a complete front to rear skid plate that can be had in pdf or machine language that many shops can run on their automated machines. When I had mine done in aluminum a few years back, it cost me $300 and that was a good buddy price.
The shop here can make these anytime but you'd need to check what shipping would be for an almost flat piece of aluminum (or steel) as long as the VX. There might be a point where the plate could be cut where it passes over a crossmember where it would be easy to make it bolt back together. This design also has the letters VX lasercut out of the front angled area as well as openings for oil changes.
Attached is the first rev of the plate:
Super VXer
NICE. send pdf to jharris@surepoint.com
Super VXer
Could I get the pdf and machine file as well? joel.theo@gmail.com
Super VXer
I'd be up for a set.. pm me if this turns into a buy
Posting Permissions
Reply With Quote
