I have never seen this mentioned on here, but in order to do the ball joint flip you absolutely need:

22mm box wrench
14mm box wrench
14mm socket (+ ratchet)
Penetrating Oil
New Cotter Pins

Just didn't want anyone to get half way in and realize the closest to 22mm they had was 7/8ths" (and nearly strip the castle nut) and realize they had no cotter pins big enough to replace the rusted in place one that you might have to drill out..... Because that is exactly what happened to me. Oh and make sure to clean up the threads on the ball joint shaft and the castle nut, because if they do not screw back on freely by hand than you cannot put it all back together at all. Hope this helps someone eventually.