Energy Suspension Part # 9.9104R (for red ones) - "Designed with a large reinforced metal plate welded to a mounting plate and molded-in. 4 1/2" tall,
2 1/2" wide. 2 per set" Evidently if you do this all you have to do is take off the old bumpstop and mount and seperate the two so you can use the stock mount with the new bumpstop. Zeus has photos of this: http://www.vehicross.info/gallery/sh...37/ppuser/1999
After you posted this, I went and got some. By "seperate" you mean have to cut off some, but not all of the factory stops. If you look at Zeus' pic, you can see that about 1" of the factory stop remains. I am going to use some square 2" steel tubing instead, I think it'll support it better. Just an FYI, I was expecting 1 1/2" longer bumpstops.