Quote Originally Posted by Ascinder View Post
So to me it looks like you cut out the lower portion of the bracket just above the large hole and slid it down, then slid in a spacer plate and welded it all in place then ground down the welds near the side of the large hole to provide clearance for the CV cup. That sound about right? If that's the case, it looks like you have about 1" or so less vertical weld than me. I'm sure Clint can take a pic of the brackets to show how I did mine.
Drop_Thread I should have just posted this before. I couldn't find any pics of your brackets, but if you did yours like BigMeatVX did his, then you should have twice as much vertical weld because you welded two vertical seams, where as I have one. Like I said in my build thread, both designs should hold up just fine, and I am not worried. It did cross my mind to weld a 5/8" rod inside the radius to connect the 3 pieces together, but I felt it was overkill. Again, USE THREADLOCK!