Mine just came in the mail yesterday. I wondered about nippling mine since I plan to get a skid plate.....
Got mine yesterday as well - installing tomorrow morning (I'll take some pics).
-- John
John Eaton
Original Owner
2001 Proton Yellow #580
Atlanta GA
http://wildtoys.com/vehicross/
http://vehicross.blogspot.com/
"Metaphors be with you"
Im planning on getting a full black diamond plate belly pan fabbed up in the upcoming months hopefully by summer. Getting my diff drop brackets fabbed this weekend.
Installed yesterday morning after draining (oil change) - piece of cake. Of course I forgot to take pictures (it was a messier than usual oil change - the paper I used under the pan didn't absorb spills so I had goo all over the floor).
-- John
And it is installed.......
I don't like that it ended up turned at that angle though.
Scary Side Story.....when I drained my oil only about a quart came out. I even jacked up the VX in various spots and never got much out. My dipstick never reads right, and really with the picture below that shows so little oil I doubt and engine could run on so little. The second picture is my new test NAPA syn. It was on sale for about $2 a bottle so i picked up 6.
![]()
Last edited by JHarris1385 : 02/17/2008 at 09:09 PM
Update....had a bit of drippage in the driveway today. Trust me it is on perfect. The instructions say to not overtighten too.
That "angle" looks about right, almost all I've installed or have seen installed on the VX are positioned with top of the valve oriented to the rear of the vehicle. I think that's a good thing as road grit won't constantly be sand-blasted into it.As for drippage, I usually take my shop rag and wipe it down real good and in the drain opening as well once done with the oil change.
Over 20 years of Isuzu enjoyment...