H3 Wheels

[ZEUS]

RIGHT ON! Did you try to steer to lock out while the wheel was mounted? You may have to adjust the lock out adjustment bolt to keep them from hitting the A-arm but I doubt it. It's too bad the center caps don't fit... but it sounds like an excuse to order some Aisin hubs!!

[Knivx]

I didn't try turning it since it didn't have a tire on and my buddy and i were just checking real quick and only had the vx up with a couple bottle jacks. Any reason the extra width would be a problem? I of course came from the 18's so i'm not too familiar with how a 16 fits on there in relation to clearances here and there. I'm hoping to go to a 265/75r16 but if thats gonna be more headaches than a t bar crank and some light trimming i might rethink that size, at least on these wheels for now. If i do have a problem with that little bit of width on the inside would wheel spacers be a way to go or maybe just suck it up and deal with a little more trouble than anticipated. Maybe i can go down to big o and have them mount me an old tire in that size to do a test fit with the tire.....

[JHarris1385]

I run that size but with a different offset.

[bigkoala1]

im surprised no one as done a photoshop of these wheels yet!!

[JHarris1385]

Or pictures have not been uploaded yet.

[Knivx]

I'm working on the pics. I have the next couple days off so if the weather is decent i'll need something to keep me busy so i'll try to throw them back on so ya'll can see them on, with out tires, but on none the less. I wanted to do some more checking on clearances such as turning and all that was mentioned earlier. Stay tuned and hopefully i'll get some pics going on the next couple days.

[Mark Miller]

Any pics yet?