Autopia Lighting Xenon White Fog Light Kit

[Pepino]

was it hard to install them were the instructions good? because i have no idea how to change anything electric im not good with wires or anythig so before i buy them i want to know if it was easy

[MSHardeman]

Pepino,

I'm not terribly electrically inclined either, but the install wasn't too bad. The ones that I bought where actually from AutoX (I think) and the instructions where a little cartoonish and vague but relatively easy to follow. If you install per the instructions it shouldn't be a big deal, but I complicated mine by also installing Moncha's auxiliary fuse box and hooking the whole kit and kaboodle to an Isuzu fog light switch. I figure if I can get through it, then you should be just fine. Just take your time and try to diagram it out first because I know that helped me.

Mark

[BeeVenom]

Pepino,
If you do get the 'autopia' lites remember the the "advertised" ones for the VX are too big and do necessitate much cutting. Go smaller. I'll install my 2.75" units when weather gets warmer.
Scott

[So-CalVX]

that only the 2.75" lights will fit without any cutting? I have been planning on going projection in those little holes there, even had some nice '92-'95 civic fog lights in mind... So, is 3" not going to fit without "customizing" my bumper?

[MSHardeman]

So-Cal,

Check out Moncha's Hella Micro D fog light installation:

http://www.vehicross.info/modules.ph...=hella+micro+d

I didn't see where he talks about altering the bumper, so these might work without any modifications (and they are sort of projection beams).

[Ascinder]

Do you have a part number for the correct size with the halos, maybe somewhere off of either the packaging or an invoice?

[MSHardeman]

Ascinder,

I still have the box that the lights came in, so I will take a picture of it tonight and post it tomorrow.