FYI, if you live in a salt/humid area, i would suggest buying and striping crappy paint and repaint right. I have a dinan hitch and it is starting to rust after a year... will look like sheot soon if i dont strip and re-paint.

on cutting holes in frame, it is not necessary if you take the rear bumper cover off. was a big pain in the arse but i dont like the ideas of putting more places for rust to start. btw, you have to drill 2 holes for the dinan hitch. it uses the 2 from the tow hooks and needs 2 more. If you decide to fish the bolt/washers through the end of the frame rail, there are a few tools that make it easier. I have one of those little pincher things that is used if you drop something down into a small area, like a nonmetallic bolt... you can pick up with this tool. A magnet on a stick is good also. Pincher worked well to fish the bolt up to the holes. Oh, and there are gussets in the end of the frame rail that make it a little more difficult to get them in. It took me 3 hours to pull bumper cover and install…. Also, If you have a small ratcheting wrench with a torqx bit then you don’t have to pull the side body cladding. Just have to cram a 2x4 in there to hold it back while you remove the rear cover bolts. Like I said pain in the arse.