3M makes a sheet adhesive.....you press the emblem on the sheet, when you lift it, the adhesive stays on the back. I'll get you a part number in the am. (generally, we buy a new emblem set...everything is pre-spaced, lined up, and ready to go. It's tough to get everything set correctly, and you only get one shot........on the other hand, a complete emblem set will cost a couple hundred bucks. If you've a bit of an artist in you, you can pull it off.....masking tape, a ruler, and a china marker (grease pen) take your time, make sure the badge backs are very clean, before you start.)