Switching Front Seats

[Raque Thomas]

Looked into that option - but I don't care for the higher position of the seat, and less travel fore and aft.

[VCrossfan]

How about leaving the tracks where they are and switching the seats only ( of course remove all to switch) Left seat on right track, Right seat on left track...

[etlsport]

the seat tracks are the same from what i can tell.. but there is a cable attached to the passenger seat fold lever that releases the sliding mechanism at the same time.. the problem is finding where that cable attaches to the seat... i looked in the seat disassembly instructions of the vx repair manual... it doesnt show where it attaches though

[marcosv6]

I've swapped mine twice. If I recall correctly, the seat mount rails are NOT the same. The seat has to be swapped to the opposite rail.

The "auto slide" mechanism is in the seat itself so you lose the feature when you swap seats. It will still slide forward and the seat back operates properly, just not "automatically".

[rowhard]

The seat has to be swapped to the opposite rail.

So bottom line, how involved is swapping the rails?

[marcosv6]

Not hard, just takes some time. Remove both seats, including tracks. Flip upside down, remove 4 bolts/seat and swap over. I believe the bolts are 1/2" but it takes some movement of the tracks forward and back to be able to remove the bolts. I didn't notice any height difference.

One odd observation: the passenger seat wears much faster than the drivers seat with everyday use. Coincidence ?

Don

[etlsport]

Not hard, just takes some time. Remove both seats, including tracks. Flip upside down, remove 4 bolts/seat and swap over. I believe the bolts are 1/2" but it takes some movement of the tracks forward and back to be able to remove the bolts. I didn't notice any height difference.

One odd observation: the passenger seat wears much faster than the drivers seat with everyday use. Coincidence ?

Don

maybe the passenger seat is used less.. so the leather hardens a bit and is more prone to cracking? since the drivers seat is used often the leather stays supple and doesnt crack as easily... be sure to condition the leather often to keep it from cracking!

[VCrossfan]

Not hard, just takes some time. Remove both seats, including tracks. Flip upside down, remove 4 bolts/seat and swap over. I believe the bolts are 1/2" but it takes some movement of the tracks forward and back to be able to remove the bolts. I didn't notice any height difference.

One odd observation: the passenger seat wears much faster than the drivers seat with everyday use. Coincidence ?

Don

Don: If your not the original owner maybe they were switched before..food for thought