I don't I have dust flaps...
Bart
Originally Posted by Kenny
I don't I have dust flaps...
Bart
Originally Posted by Kenny
you know, the plastic fender liners... but if that's not it, I'm thinkin' CV time. I'd be inclined to swap both entire axle assemblies, than do the CV's themselves. I don't know for sure on our car(have not had need) but it is the easy way out most times
Well, I don't really have much to go on yet other than this sound. Driving the VX does not seem any different. No noises going forward, no vibrations, nothing.
Bart
Originally Posted by Chopper
Bart,
Have you checked your CV boots real close ?
No sir, not yet. What should I be looking for? I have been underneath 3 or 4 times since returning from Moab, and I did not seen anything weird (leaks, etc).
Bart
Originally Posted by Ldub
The conical rubber boots on either end of the half shaft (between the front third member & the hub (back side of where front wheel bolts on).
Check them all around for tears/evidence of grease.
If one had a tear, it might possibly make a popping noise as it rotates...that's about all that comes readily to mind.
Good Luck.![]()
Turn up volume on stereo...no more noise...problem solved!![]()
Billy Oliver
15xIronman
My Sponsors:
Accelerate3Coaching
TriSports.com (PM me for 1 time use 20% off code)