My mode position switch came in today!!!

[Ldub]

Thanks for the tip Jim, since I'm already under there today, I think I'll do just that.

[JHarris1385]

Where exactally should that wrap go? I was just under there today re-lifting it to put my pro-comps back on and take the 20's off.

[SilverBullet75]

Ok... it's a VERY crude image, I know... (wow... really hard to write using a touch pad on a laptop)

Wrap the area with the cheezy grey texture... See how close it is to the switch?
Hope this helps.
Sorry so crude.
Don't mind my oil leak... that's next week's project.

[Triathlete]

Just a quick question...is there a gasket of some sort where that switch is attached? I seem to have a very slight fluid leak that appears to be coming from that same area.

[SilverBullet75]

I would expect there to be an oil seal on the actual shaft that the mode switch slides over. The shaft goes straight into the transmission. I don't have any details though... sorry.