Speedo Cluster Failure

[Kenny]

There are gauge fuses in the panel next to your left knee. If it's not a fuse, then see if a harness plug came unplugged in the back of your speedo cluster.


If not those two, I'd try out a Scangauge to see if a speed, rpm, etc.. signal is available and is being sent. If no signal is found, then uh-oh... I hate to think.

Good Luck.

[LittleBeast]

Found the "gauge" fuse in the fuse box it sure is blown and putting in another one immediately blows it so, looks like I will be tearing apart the dash yet again.

[VX crazy]

Must be all those 'new bulbs' that look so good.....sorry to hear about the problem

[Kenny]

Found the "gauge" fuse in the fuse box it sure is blown and putting in another one immediately blows it so, looks like I will be tearing apart the dash yet again.

I had a blown fuse in there too after ripping the cluster out a few times. Take a look for something hitting the bare copper lines along the back of the cluster - or look for a few scorch marks on the copper lines (a have a few of those from placing the cluster with the ignition on ...).

I'd undo the screws and then pull out the cluster a bit first without unplugging anything and then try a new fuse - it could rule out that something back there is pushing against a bare copper lead...

Good Luck.