Headliner removal

[Ldub]

A pillar comes off with gentle prying, starting at the top.

Once you decide on loca., make a small hole in the headliner & snake a wire hanger over to your wire.
Tape the wire to the end of the hanger, pull it out through the hole.

[nfpgasmask]

Hmmm, that would be an option, but I was hoping to get a piece of ABS or aluminium under the headliner to bolt to, thus creating a tighter fit. I guess I will have to see how things will fit once I get the guage. Perhaps I could get a way with your idea....

Thanks-

Bart

A pillar comes off with gentle prying, starting at the top.

Once you decide on loca., make a small hole in the headliner & snake a wire hanger over to your wire.
Tape the wire to the end of the hanger, pull it out through the hole.

[etlsport]

you can get the front of the headliner down very easily.. remove the visors with a couple of screws (i forget how many) the" OH @#$#" handles with 2 screws (one on each side of the handle) i think you may also need to pull the weather stripping down off the door, which is also easy to pull out and push back in, then you can gently pull down on the front of it and it comes down pretty easy.. just dont pull too far or hard or you will crease it behind your seats

[biju]

to mount my ddc controller i did the following:

• remove driver/passenger 'oh-sh*t' handles
• remove weather stripping just past a-pillar
• remove a pillars (they just snap off)
• remove sunvisors
• remove sunvisor 'snap bar' plastic piece (it just snaps off after the screw is removed. just pull straight down with some force)

this allows you to pull the front part of the headliner down to mount to, etc.

best of luck, bart!

-bij

[nfpgasmask]

Cool, danke everyone!

Bart

[etlsport]

to remove the A pillars... pull from the top straight across the windshield... then lift up towards the OH @$%! handle (theres a plastic hook at the bottom of the a pillar that gets all messed up if you just yank it out along the windshield)

[nfpgasmask]

Cool, yeah, I definitely don't want to snap any fasteners or anything...

Thanks,

Bart

to remove the A pillars... pull from the top straight across the windshield... then lift up towards the OH @$%! handle (theres a plastic hook at the bottom of the a pillar that gets all messed up if you just yank it out along the windshield)

[rowhard]

insert .02. Just went out to my beloved VX to check this out. Something else you might think about doing is this. (Did you read my thread awhile back about the door handle repair? There is a reference to a 'Bone Tool' sold by ipdusa dot com, 5 bucks, but it you happen to have some hard plastic laying around you could make one). Anyway, using the bone tool, you could work the cable into the the leading edge of the head liner then run the cable down under the rubber seal between the A-pillar and door right down to the side of the dash and underneath to the OBD plug. This might be a way to prevent breaking anything in the A pillar cover. When I installed the map lights in place of the useless rear view mirror, I was able to pull the headliner leading edge down to feed the mirror map light wiring thru to the aircraft style lights that I installed. Pictures are in my gallery. Just another thought Bart.