Different type of window problem...

[MrCrowley]

That doesnt sound like a VX specific failure- but a typical electric window failure. My wife's 1998 Acura CL had the same thing happen. I think it was more of a fray, then tangle, then snap! Luckily, it was just barely under warranty at the time (whew!). I think motor, wiring, brackets, cables, switch, and alignment are about the only components that comprise the window system and can fail. At least it wasnt an expensive motor failure! But it is still inconvenient

[gunpackingpoet]

I just recently got my 99 VX back, and managed to fix the window problem on the driver's side. I asked my brother why he disconnected the power window switch on the passenger side, and he said 'because people keep pushing it'... boy was he lying.

I have the same problem right now on that passenger side window. How much did it cost and what exactly did you buy?

How difficult is it to get this up and running?

Thanks!

[rocket man]

I would suggest you reiview some of the old threads on this subject. This is probably THE most often complained about problem in this fantastic vehicle.

I had the same problem with the passenger side not working...I removed the door panel and the plastic seal(looks like a sheet off a "leaf Glad bag") that will give you a peek as to what your problem is...

If it is like mine....the Plastic Supprt Tabs that grip and stabalize the window panel broke..

I simply removed the , "Tabs" enough to "reglue" with a compound called "weld it"...and its been bullet-proof perfect for past 2 years....I did some other stuff too but only because I screwed up and ended up having to take out the window lift assembly....thank god this isn't my day yob!!!!......But...da..daaaa!!!....I got all the wires(cables) and do-hickey's reassembled and the whole damn thing worked!!!!....that time I amazed myself!! ;oog;

PS.... it's a Mickey Mouse repair for sure....but in this case Mickey did a better job than " Mr.Isuzu San" and it doesn't cost U $700 bucks...Please check the old posts and good luck!!

[joe-yamma]

Thanks for the advice rocket man. Unfortunately, the plastic tabs are fine. The dealership re-glued them back when they fixed the old problem. I think they replaced the motor, not the regulator (i'll have to check on my old service report/invoice).

I purchased a new regulator and it was around $80. I'll let you guys know how it goes this weekend when I fix it.

[gunpackingpoet]

Thanks for the advice rocket man. Unfortunately, the plastic tabs are fine. The dealership re-glued them back when they fixed the old problem. I think they replaced the motor, not the regulator (i'll have to check on my old service report/invoice).

I purchased a new regulator and it was around $80. I'll let you guys know how it goes this weekend when I fix it.

Joe, so you bought a new regulator? I assume you couldn't buy that snapped cable, correct? That's the issue I have right now, and I'm hoping to replace it if I can. If I need to buy a regulator, then I will, but I wanted to see how much Merlin let you have it for.

Thanks.