coleman safari roof basket

[CrnCnn]

can you get the spare tire mount for this as well?

[etlsport]

silverbullet - i have mine mounted to a non stock rack.. i was thinking about it earlier and thinking.. im pretty sure i could mount it directly to the rails that are on all VXs even without the roof rack.. but not sure yet, im going to try this weekend cause that would be cool

crncnn - i dont think coleman makes any acessories for it.. when i get a full sized spare i planned on taking a square plate with a threaded rod welded onto it, pushed the rod up through the bottom of the rack and through the center of the tire, then taking the plate that holds the stock spare in and putting that over the threaded rod, drilling a hole through the rod and putting a key lock in the hole so prevent the nuts from being taken off... ive also designed a light rack for it already that ill be building when i get my lights and also plan on getting a yakima mount for a shovel/axe and seeing how well that fits on there

nfp - sorry i didnt get the pics of the mounts yet.. it was a long night.. hopefully tomorrow

[etlsport]

got photos of the mounts taken today before the rain came.. it actually came with easy to use knobs where i have the hex nuts, i just replaced them because a. the knobs stuck up kinda far and b. the hex nuts require much more effort to remove... once im sure of the position and configuration ill be cutting the ends of the metal U piece that goes under the crossbar so it doesnt stick up where my cargo will need to sit
click on the pictures to make them larger

[nfpgasmask]

Hey, I just wanted to throw another reply on this thread. I bought the Coleman rack from Costco, very good price for a nice sturdy rack ($128 shipped iirc). But, with the stock Yakima wing bars, the rack did not line up right. Basically, if I centered the front mounts on the front bar, the rear mounts were off by 3/4". There is no way to correct this by moving the mounts to another spot on the rack either.

Since the rack came in two halves that you connect and screw together, I was able to trim the tubes down by 3/4" with a cheapo tube cutter from Home Depot. But, in doing this, I lost the screw holes that hold it together and had to drill new ones, that I put bolts through to hold things together. It took a moderate amount of work to accomplish, but in the end it works perfectly and looks good.

I just wanted to make everyone aware of this in case anyone was thinking of buying one of these.

Bart

PS - Pictures of this rack installed are on my website.

[etlsport]

sorry it turned into such a project for you bart, the rack lined up nicely on my roof rack, but i dont have the stock one, so its possible my mounts are slightly off of where the stock one was, or maybe since my crossbars are smaller than the stock ones the 3/4 inch didnt make much difference.. glad you got it on there though

[nfpgasmask]

No need to apologize! Its a great rack for the price, and now that I have it shortened a little, it fits perfectly! I just wanted to post about it since not everyone is keen on modding stuff like I am.

It fits my spare well and I think I will have enough room for 10 gallons of extra liquid money. I plan on getting everything ready for Moab this weekend so I will post pics of my complete Moab VX rig when done!

Thanks!

Bart

sorry it turned into such a project for you bart, the rack lined up nicely on my roof rack, but i dont have the stock one, so its possible my mounts are slightly off of where the stock one was, or maybe since my crossbars are smaller than the stock ones the 3/4 inch didnt make much difference.. glad you got it on there though