Reverse Signal Wire : ???

[biju]

haha... so, if I don't show up with a hook for a hand - will I disappoint? If so, I'll get right on that!

<hijack>

i was telling pbkid in a PM that I'm not sure if I'll get the system done before moab... I'm working 13 hour days 7 days a week lately with no relief in sight. So if I pull it off it will be a small miracle. When I do find time I'll have to crank out as much as possible. In the rush, well, you might just get to see some gory pix if all doesn't go well...!

</hijack>

On the reverse signal wire front... I'll post a pic of that in this thread when I get home. I'll also eventually put a pic of it in my install thread. Rowhard - seriously if you're at Zu this year I'll have to buy you a beer. Your quick reply helped me troubleshoot the issue in less than 15 minutes. (Only after I spent 2 hours testing misc. wires, etc., by myself... hahaha...)

-biju.

[rowhard]

biju, glad to be of assistants. MOAB is very doubtful, but do raise a jar for me. Hopefully Eric (PHO2GR4) will be there with all of his camera's to document this years ZuZoo.

[biju]

...here's a pic of the reverse signal wire i found. tap into this to automatically power on/switch to your backup camera when in reverse:



-biju.

[Ldub]

That bracket under the shifter looks a little rusty...should probably be powder coated. -

[biju]

That bracket under the shifter looks a little rusty...

Twitch. twitch twitch. *blink*... twitch.

-biju.

[djkymar]

i have a question.
That reverse signal wire is that any power going on trigth that on no?
Would it be positive or negovite or something else?
Thanks

[djkymar]

okay never mind i figured. That wire has a power when you shift into reverse otherwise it doesnt have any.